Refrigerator Malfunction? Here’s How To Replace Your Kenmore Control Board In 15 Minutes!

Replacing a Kenmore refrigerator control board can seem daunting, but with the right guidance, it’s a task that can be accomplished by most homeowners. This comprehensive guide will provide you with step-by-step instructions on how to replace the control board on your Kenmore refrigerator.

Tools and Materials

Before you begin, gather the following tools and materials:

• Phillips head screwdriver
• Flat head screwdriver
• New Kenmore refrigerator control board
• Electrical tape
• Wire strippers (optional)

Safety Precautions

• Unplug the refrigerator from the electrical outlet.
• Wear gloves to protect your hands from sharp edges.
• Avoid touching the electrical components inside the refrigerator.

Step 1: Locate the Control Board

• Open the refrigerator door and locate the control panel.
• Remove the screws holding the control panel in place.
• Gently pull the control panel forward.
• The control board is usually located behind the control panel.

Step 2: Disconnect the Wires

• Take a picture of the wiring connections before disconnecting any wires. This will help you reconnect them correctly later.
• Use a flat head screwdriver to gently pry the wire connectors off the control board.
• If the wires are crimped, use wire strippers to cut the crimp and expose the bare wire.

Step 3: Remove the Control Board

• Use a Phillips head screwdriver to remove the screws holding the control board in place.
• Carefully lift the control board out of the refrigerator.

Step 4: Install the New Control Board

• Place the new control board in the refrigerator.
• Align the screw holes and secure the control board with the screws.

Step 5: Reconnect the Wires

• Connect the wires to the new control board using the wire connectors. Make sure to match the colors of the wires to the corresponding terminals on the control board.
• If you cut the wires in Step 2, strip the ends of the wires and crimp on new connectors.

Step 6: Reinstall the Control Panel

• Insert the control panel back into the refrigerator and secure it with the screws.

Step 7: Test the Refrigerator

• Plug the refrigerator back into the electrical outlet.
• Turn on the refrigerator and check if it is working properly.
• If the refrigerator is not working properly, double-check the wiring connections and make sure the control board is securely installed.

Troubleshooting

• If the refrigerator does not turn on, check the electrical outlet and the power cord.
• If the refrigerator is not cooling properly, check the condenser coils and make sure they are clean.
• If the ice maker is not working, check the water line and the ice maker itself.

In a nutshell

Replacing a Kenmore refrigerator control board is a relatively simple task that can be completed in about an hour. By following these step-by-step instructions, you can save money and keep your refrigerator running smoothly.

Frequently Discussed Topics

Q: Can I replace the control board myself?
A: Yes, with the right tools and guidance, most homeowners can replace the control board on their own.

Q: How much does it cost to replace a refrigerator control board?
A: The cost of a new control board can range from $50 to $200, depending on the model of your refrigerator.

Q: What are the signs of a faulty control board?
A: Common signs of a faulty control board include the refrigerator not turning on, not cooling properly, or the ice maker not working.