Unlock the mystery: a step-by-step blueprint for replacing your samsung dryer belt
What To Know
- Replacing a Samsung dryer belt is a relatively simple task that can be completed in under an hour.
- Once the belt is tensioned, reattach the back panel to the dryer.
- If the dryer is making a squealing noise, the belt may be too tight.
Replacing a Samsung dryer belt is a relatively simple task that can be completed in under an hour. By following these step-by-step instructions, you can save yourself the cost of a repair technician and keep your dryer running smoothly.
Tools and Materials You’ll Need:
- New Samsung dryer belt
- Screwdriver
- Putty knife or flat-head screwdriver
- Adjustable wrench
- Flashlight (optional)
Step 1: Unplug the Dryer and Gather Your Tools
Before you begin working on the dryer, unplug it from the electrical outlet. This will prevent any electrical accidents from occurring.
Step 2: Remove the Back Panel
Locate the screws holding the back panel in place and remove them using a screwdriver. Carefully lift the panel off the dryer and set it aside.
Step 3: Locate the Drive Belt
Once the back panel is removed, you will be able to see the drive belt. It is a thick, rubber belt that connects the motor to the drum.
Step 4: Remove the Old Drive Belt
Locate the tensioner pulley, which is a small wheel that keeps the belt tight. Using a putty knife or flat-head screwdriver, gently pry the belt off the tensioner pulley. Once the belt is loose, you can remove it from the dryer.
Step 5: Install the New Drive Belt
Take the new drive belt and place it around the motor pulley. Then, route it around the tensioner pulley and onto the drum pulley. Make sure the belt is seated properly on all three pulleys.
Step 6: Adjust the Tension
Once the new belt is in place, you need to adjust the tension. Using an adjustable wrench, turn the tensioner pulley clockwise until the belt is tight but not overly so. You should be able to deflect the belt about 1/2 inch when you press on it with your thumb.
Step 7: Reattach the Back Panel
Once the belt is tensioned, reattach the back panel to the dryer. Secure it with the screws that you removed earlier.
Step 8: Plug in the Dryer and Test
Plug the dryer back into the electrical outlet and turn it on. Let it run for a few minutes to make sure that the new belt is working properly.
Troubleshooting Tips
- If the dryer is making a squealing noise, the belt may be too tight. Loosen the tensioner pulley slightly.
- If the dryer is not drying clothes properly, the belt may be too loose. Tighten the tensioner pulley slightly.
- If the belt breaks again shortly after replacing it, there may be another problem with the dryer. Contact a qualified repair technician for assistance.
Information You Need to Know
Q: How often should I replace the dryer belt?
A: The dryer belt should be replaced every 5-7 years or after 1,000 hours of use.
Q: Can I use a belt from another brand of dryer?
A: No, it is important to use a genuine Samsung dryer belt. Using a different belt may not fit properly or could damage the dryer.
Q: How do I know if my dryer belt is broken?
A: Signs of a broken dryer belt include:
- The dryer is not tumbling
- The dryer is making a squealing noise
